Skip to main content
OpenID

News

  • ElkArte - Just Installed!

Recent Posts

11
Energy History Display / Re: Two-stage heating
Last post by jimmy -
Has this been addressed? I agree it would be super helpful! Thanks!
12
News/Updates/General Messages / Re: Increased max number of users.
Last post by Jackson -
THANK YOU!!!
13
News/Updates/General Messages / Re: Website will be invite only
Last post by Jackson -
Thank you very much for adding slots!  I am logged into the site and had a huge sigh of relief when I clicked on the "Automatically control the humidity based on outside temperature" box.  You have no idea what a relief it is! 

FYI I have attempted to email to that address 2 separate occasions - see below:
Delivery incomplete
There was a temporary problem delivering your message to admin@mynestreports.com. Gmail will retry for 20 more hours. You'll be notified if the delivery fails permanently.
The response was:
DNS Error: 14392918 DNS type 'mx' lookup of mynestreports.com responded with code SERVFAIL

Thanks again!!!!
14
News/Updates/General Messages / Increased max number of users.
Last post by admin -
Due to increase interest in Mynestreports.com I have increased the number of allowed users. I have opened up 40 more spaces.
15
News/Updates/General Messages / Re: Website will be invite only
Last post by admin -
Seend an email to admin@mynestreports.com  with your nest email.. not your password. I will add you.
16
News/Updates/General Messages / Re: Website will be invite only
Last post by Jackson -
Same.

I just realized that my Nest did not control the humidity based on the outside temperature and had mold in my closet as a result of over humidification during cold temps.  I've attempted to email several times and my emails are getting rejected by server - DNS Error: 10480399 DNS type 'mx' lookup of mynestreports.com responded with code SERVFAIL

Please invite me!!!
17
Settings are checked aprox once perhour

So the only way to check operation is to make a noticeable change, then wait for an hour to see if it takes? Not a criticism, just a question. Is there another way to see if it is working or not?

Paul
18
Settings are checked aprox once perhour
19
News/Updates/General Messages / Humidity Control - How to tell or test?
Last post by PaulProe -
I have enabled the Humidity control for my system but am unsure if it is working or not after the updates. I've tried changing settings online to see if the furnace responds but don't see a difference - maybe there's a long time for it to resolve?

I've set the check marks on the email for changes to humidity but I am not receiving any emails (yes, I check the spam folder also)

How can I tell if it is working or not?

Thanks

Paul
20
General Discussion / Re: Where is the App?
Last post by mjcech -
Could I have you manually add me as well?